HENKEL - Ceresit |
| CT 83 HEAT PLAQUE STICKY PLASTER |
 |
Definition: Leaf strengthened sticky plaster for the heat isolation board to stick.
Applicaition areas : It is used in the heat isolation of the building the front and the back side. It is also used to fix the extrude – expand polystrene, stone-fibre, rock – fibre board to the wall.
Product Advantages: Because of the leaf strengthened it would not be occur a crack between wall and board. It provides flexibility.
Technical Properties :
- Density : 1.44kg/lt
- Anchor plugging : minimum 24 hours later
- Chemical structure : including fibre syntethic additive cement
- Application Heat in outdoors : 20 minutes
- Application heat : 5 C to 30 C degree
- Mixture rate : 25 kg ceresit CT 83 : 7.5 lt water
- Application time : 2 hours
- Shelf existance : 12 months
- Sticky endurance : ?1.0 N/mm2 EN1 2004
Covering the board with ceresit CT 85 stucco and glass fibre minimum 48 hours later
Expenditure : 4 – 4.5 kg/m2
Application : The sticky board and surfaces should be dry, clean and carried.The oil and dirt should be cleaned.The surface repair must be done before 24 hours with ceresit CT 20.Ceresit CT83 should be mixed under cold water until the lumps disappear.The mixture fixed equal spreading to the wall with pointed or geared comb back to the polystrene with trowel after 5 minute rested.
Attention : Because of the cement bases the water and alcali gives reaction.If any contact with your skin wash througly.If any eyes contact go to doctor.
