Definition: The special isolation cement against the water in mineral surface.

Application Area: In horizontal and prependicular look at first the building & construction elements of the moisture on the floor. This product uses in swimming pool , tank izolation , and also in against the uncompressed surface water isolation and also using old building and construction element in negative isolation towards the negative isolation of compressed water bricks etc. Surface should not be use. You should use this product against the uncompressed under ground water , main curtain wall the isolation of faince in balcony and terrace with cresit emulsion and also should use in about 5 metres only for the drink water tank inside isolation ; if you are not sure of floor quality and for the reason of damage in the constraction element action.

Product Advantages :

Technical Properties :

Mixture Rate :

25 kg Ceresit CR 65:   6.0 - 6.5 lt water

25 kg Ceresit CR 65:  3 litre Ceresit Emulsion 6 lt water (wet wolume, main curtain,  balcony and terrace)

25 kg Ceresit CR 65:  4 lt cresit Emulsion. 5 lt water ferrocrete water tank , swimming pool

Work time :                                                        Approximately 2 hours
Work Conditions :                                            5 C degree to 30 C degree
Rainforced :                                                      End of 4 hours
Walk over :                                                        2 days
Flexibility :                                                        >5 N/mm² ( in dry atmosphere 28 days )
                                                                          >=3 N/mm² (  in wet atmosphere 28 days )
Pressure :                                                       >20 / mm² ( 28 days )
Water pressure with cresit emulsion :      1,5 bar ( 28 gün )
Shelf Exsistance :                                           inside over 5 C degree one year
Application Heat :                                            5 C degree to 30 C degree

Consumption :

Maximum thickness must be 5 mm and the consumption 8 kg/ m²

Application :  All surface should be moisture before the application. It should be cleaned from oil , dirty or paint. All concrete repeair should be completed before 24 hours with cresit CD 22 or cresit CT 20. Sharp edges and corner should be rounded with CT 20 plaster repair only to make bevel. The holes should be filled with right system cresit Pu foam cresit CX1 Cresit CR 65  with clean water and in the right rotation mixing till the lumps dissappear ( 400 – 600 minutes ) The mixture applies 2-3 layer. In corner advised glass-vibre application. You should be sure dry of 1 layer before the 2. layer application. After the 3. days of application should be started the faience application.

Attention:  When the application fresh is ( the first 24 hours ) should be protected from directly sunlight. In water tank isolation you can fill with water after 7 days later while the product concrete is give a reaction with water. If there is any contact to your skin or eyes , wash directly with water.