HENKEL - Ceresit
|
| CP 44 FLEXDITH BITUMEN CAOUTCOUCH WATER ISOLATION |
 |
Definition: One component bitumen- caoutcouch based isolation product with polystyrene
Applicaition areas : It can be used in structure elemenths underground level , underground garages and places against the water isolation and all inside and outside minneralled based surfaces. It is used in isolation and drainage plates sticky. Ceresit CP 44 should be used only in possitive water isolation. It is not used in flat roof and tank isolation.
Product Advantages:
- Water impervious
- Crack covering
- Eruptionable
When the second component CP 44 HP is used;
- after 1,5 hours lasting rain
- Fast dry
Technical Properties :
- Denstiy : 0,65 kg/lt
- Chemical based : bitumen – caoutcouch
- Working heat : 5 C degree to 30 C degree
- Second component working time: after putting approximatelly 2 hours
- Mixture rate one package ceresit CP 44 HP : 30 lt ceresit CP 44 flexditcht
- Application Heat : 5 C degree to 30 C degree
- Load Endurance with second component : end of 3-7 days
- Shore a hardness : to 15
- Rupture strength : Approximately % 200
- Softning point : 120 C degree
- Pulling resistence : approximately 0,2 n/mm2
- Shelf existance : in cool places 12 months in a packaged way
Crack Cover DIN 18195
Ceresit CP 44 Dry Film Thickness mm |
Crack Width |
4.0 |
2 |
4.8 |
5 |
Expenditure :
|
Thickness (mm) |
Consumption (lt/m²) |
System |
|
wet |
dry |
|||
Floor moisture |
2 - 4 |
1.6 - 3.2 |
2 - 4 |
* |
Unpressure water |
3 - 5 |
2.4 - 4 |
3 - 5 |
2 layer |
Pressure water |
4 |
3.2 - 4.8 |
4 - 6 |
2 layer between glass filet |
Plaque Sticky |
* |
* |
1 |
* |
Application: you can apply over all old bitumen and carried, clean , dry or a little moistured minnerled. All corners should be rounded before 3-4 hours from application with ceresit CT 20 in 4 cm calibre inside bevel. The dameged surfaces and seams should be repaired and filled. You should work with CC 81 and ceresit CR 65 combined in the ciritic union point of wall or bottom. The big pore under surfaces should be filled before the application with ceresit CP 44 to avoid the bubbles after the application occurs. Ceresit CP 44 is applied after the lining with brush/trowel right thickness of homogeneous. You should be applied reinforced glass-fibre against the rough places, main curtain walls with bricks and big stones in it, and against the pressured water isolation. The fresh application should be protected towards the rain. The drying prove to be true depends on the wheather condition and moisture between 3 or 7 days. If earlier drying you want, you should used second component ceresit CP 44 HP with your product. For the doubled component application, you should put 1 suck ceresit CP 44 HP and 30 liters ceresit CP 44 flexdicht to make a homogenous mixture. The mixture you have can work to layer.
Attention: You should apply 5 to 30 degree heat without directly to the sunlight. All information is given according to take the moisture % 50 and 23 degree heating. You have to wash immediately if any contact with your skin. If any contact with your eyes go to doctor. The dry product can only be cleaned with solvent.
