HENKEL - Ceresit |
| CE 144 EPOXY FUGA |
 |
Definition: 3 component epoxy resine and cuvars sand based ceramic and fiance seam filled plaster.
Applicaition areas: For the ceramic and fiance seams against chemical, kitchen, medicine fabrics. Small pulley block and slaughter’s house, the effect of chemical abrasive.
Product Advantages:
- Do not need solvent
- High aderance
- High endurance towards chemicals
- Easy application
Technical Properties :
- Application heat : 5 C to 30 C degree
- Working time (at 20 C degree) : approximately 1.5 hours
- First endurance : end of 24 hour
- Final cure : end of 7 days
- Pressure endurance : 380 kg / cm2
- Sticky endurance : 45 kg /cm2
- Sticky endurance in wet condition : 44 kg / cm2
- Storaged : 12 months (5 – 25 C degree)
Expenditure : 1 kg / m2
Chemical endurance table : There is no damages in Ceresit C 144 epoxy fuga against 8 weeks chemical endurance.
Water |
Lasting |
Sulphuric acid |
%10 |
Orange juice |
Lasting |
Phosphoric acid |
%10 |
Beer |
Lasting |
Hydrochlorite acid |
%36 |
Sunflower oil |
Lasting |
Acetic acid |
%10 |
Hydrogen Peroxide |
%3 |
Nitrite acid |
%30 |
Sodium Hypochlorite |
%14 |
Formic acid |
%10 |
Sodium Hydroxide |
%10 |
Ethanol |
%95 |
Ammoniac E. |
%10 |
Lactic acid |
%10 |
Application: Every 3 component is mixed with 400 per / min mixer, first epoxy resine and like strenghtened homogeneous. The cuvars filling is put under the mixing over mixture. With the help of clean cautchouc trowel is applied on the before cleaned seams. After one hour from application with clean sponge and hot water is cleaned the seams.The tools cleaning can be made by hot water.
Attention : Get away from the skin contact.You should wear a protector glove during the application.The product should be cleaned with hot water and soap when it is fresh.The product steam must not be breathed. During the application the temperature should be over 5 C degree.
